ENEC mark scope

– clause 2.2 Class 0 luminaires are not in the scope of the Agreement;

– clause 3.2 For luminaires to be connected directly to the supply the rated voltage shall be 230 V or a range
including 230 V. , or for 3 phase supply a range including 400 V.

– clause 3.3 The Certification Body, granting the licence, shall check the correct wording of the mounting
instructions, if any, in a language acceptable to it. The manufacturer shall take care of the correct
wording in other required languages (with or without assistance of the Certification Body).

– clause 5.2.1 Luminaires provided with a plug shall be equipped with one of the following types
IEC 83
– class I: luminaires – Standard sheets: C4
– class II: luminaires – Standard sheets: C5*, C6
*) Identical to EN 50075
Luminaires for use in Great Britain:
IEC 83
– Class I: Standard sheets: B1, B2

GENERAL NOTE: For Class I luminaires the plug may be in accordance with the National Standard Sheet of the country to which the luminaire will be marketed.

– clause 5.2.2 Flexible cables and cords with PVC insulation are not accepted on luminaires intended for use outdoors.
For horticulture luminaires the ENEC Requirement Sheet ERS 002 has to be applied and indicated on the license.

– Spain: Special national conditions for Spain, as indicated in annex ZB to EN 60598-2-22 (see corrigendum of October 2007).
Any luminaire for emergency lighting intended to be marketed in Spain shall carry a warning (e.g. in the instruction sheet) stating either,
* when checked satisfactorily to the above mentioned national conditions:
«Este aparato cumple con los requisitos adicionales para los locales de publica concurrencia en Espana»
(«This appliance has been checked satisfactorily to the additional regulatory requirements for public buildings areas in Spain»)
* when not checked to the above mentioned national conditions:
En este aparato no se han comprobado los requisitos adicionales para los locales de publica concurrencia en Espana»
(«This appliance has not been checked to the additional regulatory requirements for public buildings areas in Spain»)

– clause 4.3 Track-systems shall exist of at least a track, supply connector, coupler and adapter.
– clause 4.3 All components according to the manufacturers catalogue shall be subject to testing.
– clause 4.3 Adapters, provided with socket outlets are not accepted, as the track-system is only intended for connection of luminaires.
– clause 4.3 Multi-adapters as a single component are excluded from the ENEC mark, as the adapter manufacturer can not control the dimensions of the essential parts of the third party track.

– clause 5 The catalogue shall not include any information about the use of the track-system or adaptor that is not controlled by the licensee.
– clause 5 ENEC mark is only allowed on the tracks or the supply connectors. ENEC mark on the single adapter is not allowed.

– clause 5.5 Warnings according to sub clauses 5.5 and 5.6 respectively shall be given either on the track-system or the mounting instructions, delivered with the track-system.
NOTE: Adapter interface components, not forming a fixed part with the luminaire can be accepted for ENEC mark if all relevant requirements of EN 60598-1 are fulfilled.
Special attention is given to the fact that adapter interface components are not covered by EN 60570 and the luminaire standard EN 60598-1 does not give a defined testing program for these products.

EN 60998-2-1, 2 and 3 – Connecting devices for low voltage circuits for household and similar purposes.
Part 2: Particular requirements

Scope: For components intended to be used only in appliances

To be used only as an accessory to EN 60998

Any appliance fitted with a Europlug and intended for use in the UK shall carry a warning label stating:
«Within the UK, this appliance may only be used when supplied from a shaver supply unit in accordance with EN 61558-2-5 and must not to be connected to a UK mains socket.»

Limitations due to Special National Conditions and A-deviations as given in the respective standard apply.

Limitations due to Special National Conditions and A-deviations as given in the standard apply.